HVAF high-speed flame spraying rod, hydraulic rod industry application

HVAF high-speed flame spraying rod, hydraulic rod industry application 

HVAF sandblasting + spraying

The process sequence of traditional HVOF spraying is as follows: the rod needs to be installed on the sand blasting machine to blast sand; Then the rod is installed in the spraying room for spraying; Melting coating; Then straighten the rod (because it deforms very badly during melting!) ; Finally, the rod is mounted on the grinder for grinding.

The process sequence of HVAF spraying is completely simplified, the rod is installed in the spraying room and sandblasted directly with HVAF equipment, and then sprayed with HVAF equipment. After spraying, the rod is mounted on the grinder for grinding. The use of HVAF equipment will save a lot of working time, the use of HVAF sandblasting will be more than 10 times faster than the traditional means, and the sand consumption is only 1/20 of the original! In addition, spraying with HVAF equipment is at least three times faster. From the economic point of view of application, the preparation of amorphous iron based coatings by HVAF is more advantageous.

HVAF + sandblasting

HVAF  + spraying

HVAF Air supersonic standard:

1, air supersonic equipment control cabinet,

2, powder feeder,

3, supersonic sandblasting powder feeder,

4, air supersonic gun,

5, propane carburetor,

6, 1 set of pipes,

7, wearing parts: 4 inch, 8 inch barrel each 1, propane gas parts 1, powder tube 1, spark plug 1. 0 type sealing ring 1 set.

Rod hydraulic rod industry

Pump rod: Wc-Co-Cr

Compressor rod: Wc-Co-Cr

Pump rod: Wc-Co-Cr

Compressor rod：Wc-Co-Cr

 HVAF high speed flame direct belt feed sandblasting and spraying rod, hydraulic rod industry applications