HVOF SX-8000 FM （float flowmeter ）（ with two spray guns.）
Supersonic spray of tungsten carbide powder
Supersonic spray of tungsten carbide powder
Description:
1 - Compact Lightweight type JP5000 HVOF spray gun kit, equipped with 4-inch and 6-inch nozzles
2 - When spraying high melting point powders (such as tungsten carbide or alloy powders), a 6-inch long nozzle can be used; while when spraying low melting point powders (such as nickel-chromium carbide powders), a 4-inch short nozzle can be used as an alternative
JP5000 HVOF spray gun ----------1pc
3 - The large spray gun JP8000 HVOF spray gun is specifically designed for the spraying of tungsten carbide powder
JP5000 spray gun weighs 4.46 kilograms and is 36 centimeters long, while the SX-JP8000 spray gun weighs 6.14 kilograms and is 51 centimeters long
JP 8000 HVOF spray gun ----------1pc
HVOF thermal spray powder
1----Tungsten carbide
WC-Co is a high-hardness cobalt-based coated powder. It is produced through a granular sintering process. It is a layer of metal cobalt coated on the surface of cast tungsten carbide as a protective and bonding layer. It has excellent resistance to abrasive wear and high-temperature oxidation, and is suitable for ultrasonic plasma spraying or HVOF ultrasonic spraying processes. It is commonly used in situations with severe wear, such as guide plates, shafts, external process rollers of continuous rolling furnaces, hard sealing surfaces, etc.
Chemical composition of the powder ：88%（WC）+12% Co）
Coating hardness: HRC65-70
2----Nickel-chromium carbonitride chromium spray powder
Description: Cr3C2-Ni Cr is a high-temperature wear-resistant and high-hardness ceramic coating. Its resistance to high-temperature oxidation can reach approximately 900°C. It is suitable for HVOF (High Velocity Oxygen Fuel) and super-sonic plasma spraying. It is commonly used for spraying coatings on "four tubes" of boilers, as well as on the blades of induced draft and exhaust fans, and high-temperature conduits.
Chemical composition of the powder: 75% (Cr3C2) - 25% (NiCr)
NiCr chrome carbide
3-nickel-chromium alloy powder
Particle size: -140 + 325 mesh, -45 + 15 microns
Hardness: 20HRC
Process: Oxygen-acetylene flame, plasma spraying, HVOF supersonic spraying
Description: Nickel-chromium alloy powder has excellent resistance to high-temperature oxidation. The coating can operate at temperatures below 980°C. The coating has good toughness and is mainly used as a protective coating for steel and low-alloy steel components under high-temperature conditions. It can also serve as an adhesive phase for carbide coatings. Fine powder can be used as the base material for coating layers of heat exchange devices and components in new energy vehicles.
